Ducati 959 Panigale Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I was trying install a termignoni and somehow took the wrong step and took off the y-connector betweent o header pipes. I cant get it back on now and think I might have remove front header to make it fit back in there.

Anyone know how I can do this. If someone is from 925 cali i will happily pay if your close enough to me to help put this piece back.
 

·
Registered
Joined
·
38 Posts
You need to raise the swing arm to gain some wiggle room

If you support the bike with a centre stand or ABBA stand or even a trolley jack with someone holding it

Remove the shock linkage swingarm bolt and lift the swing arm Up as far as you can and that will give you enough room to put the y piece back in.
 

·
Registered
Joined
·
892 Posts
Yep, the three options are removing the rear bank exhaust pipe, removing the rear suspension linkage (like what @flatstick959 did), or have the special case where it falls off with minimal effort or teeny bit of grunt.


Here was my thread where I essentially asked the same: Removing Header Pipes
 
1 - 3 of 3 Posts
Top